Origin	Spain
Brand Name	Europea de Pinturas Especiales, S.L.

THICK LAYER 2/C ESMALTPOLY

ALIPHATIC POLYURETHANE ENAMEL FOR HIGH THICKNESS 2/C FINISHING.

Product description

-          Definition: Polyurethane Acrylic Enamel of two components catalyzed with Pure Aliphatic Isocyanate for maximum exterior protection and aggressive chemicals products protection.

-          Use: As a termination layer of polyurethane’s especial process to protect elements exposed to weather, industrial atmospheres, marine environment, aggressive environments, oil spills, solvents, acids and alkalis etc. 

Properties: High gloss finish, with extraordinary color stability and retention and film hardness that allows it to act as anti dust. High mechanical, abrasive and environment resistance. Excellent chemical resistance to solvents and UV rays. Not yellowing.

Technical information

Aspect……………………………..GLOSS, SATIN, MATTE

Color………………………………RAL SHADE, UNE, PANTONE

Density…………………………….1.3 Kg/Lt

Proportion  and

lifetime mixing…………………….4/1  8 to 10 HOURS

Viscosity…………………………..40” FORD 6

Volume solids……………………..58 %

Recommended thickness..................80 - 100 MICRONS

Theoretical performance...................7,2 M²/Lt

Drying 20 ºC/70% RH

         Touch.......................................3 HOURS

         Repaint………………………12 HOURS

Norm……………………………….ET – 306 - A

Application Instructions

·         Method

      Brush, Roller, Airbrush gun, Air-Less.

·         Dilution

If necessary use our Polyurethane Solvent.

·         Cleaning

After use, clean all equipment with our Polyurethane Solvent.

Surfaces preparation

It must be applied over a properly primed surface. The primer surface must be clean, dry and free of grease. In slightly rusty surfaces, previously apply a good coat of LYMUSE 25 or H-200. In blasted and clean surfaces apply IXIMA 2/C or H-400 leaving it to dry for 24 hours before applying THICK LAYER 2/C ESMALTPOLY.  

Hygiene and security

·         Being a flammable product, keep way from sparks and flames.

·         It is recommended the most appropriate respiratory protection to each case by the corresponding mask.

·         Avoid prolonged inhalation of solvent vapors.

·         During the application have adequate ventilation and maintain a constant air renewal.

·         Avoid eye and skin contact, if product comes in contact with skin, wash with soap and water. 

·         If the product splashes eyes, rinse with water several times; always consult your doctor or the National Institute of Toxicology, Phone Number 91 – 562.84.69.

Comments

*        When performance practical calculation take place it is necessary to be considered product losses by surface irregularities and application system.

*        The solvent addiction proportionally modifies the solid content in the paint and therefore the thickness of wet film.

*        Our Technical Department will be pleased to answer as many as questions that you are planning to ask.

Our technical service is at your disposal for further information in this booklet as well as to advise on special treatments, systems, process and the best products, according to the surface, environments and needs they wish to cover.

In this sheet, we just trying to inform and advice to our best knowledge, based on experience and research. We cannot be responsible for the consequences of using this product when application conditions and circumstances fall out of our reach and control.